Solidstrip

Plastic Media Blasting - A Primer

blue bar image

Sandblasting, using compressed air, has been traditionally used to prepare surfaces for coatings. The sharp particles of sand, aluminum oxide, steel grit, and other media abraded the particular surface. Incidental corrosion, rust, and old coatings were removed in the process, leaving a good surface for paint adhesion. Substrates other than steel often could not tolerate this aggressive surface preparation and, as a consequence, wet chemical strippers were employed to remove coatings and hand sanding was utilized to remove corrosion, rust, and other oxides. Aluminum, brass, and plastic composites, including fiberglass, were treated in this way. Airframes, including "Alclad" surfaces where a thin coating of pure aluminum is bonded to the alloy surface, were painstakingly treated to remove old coatings prior to repainting. Residue from the use of these wet chemical strippers contributed to hazardous waste generation and disposal problems, now considered to be an international issue. The hazardous waste issue has greatly motivated the implementation of a new technology for coatings removal, Plastic Media Blasting (PMB.) It is similar to the sandblasting techniques employed on steel surfaces, but uses modified equipment and engineered Solidstrip® Plastic Abrasive as the blasting media.

Recovered and air washed, screened and recycled Solidstrip® Plastic Abrasive has now been proven to significantly reduce the generation of hazardous waste. In addition, the use of PMB has proven to be faster, less damaging to the substrate, and much less expensive than wet chemicals.

The United States Air Force, Navy, Army, Coast Guard, and commercial aviation are rapidly switching to PMB for stripping airframes, ground support equipment, and helicopters, including rotors and composite panels. PMB programs have also been initiated in the private sector for ground transportation, marine, and electronic industry applications.

In practice, sandblasting techniques are greatly modified. PMB equipment, designed for low operating pressures while maintaining effective medium flow, is coupled with comprehensive operator training and Solidstrip® Plastic Abrasive. Since Solidstrip® Plastic Abrasive is harder than the coatings to be removed, yet softer than the substrate, coatings can actually be stripped three or four times without damage to the surface (e.g., "Alclad" surfaces.) Similarly, fragile composites can be stripped without exposing a bloom of fibers on the surface, leaving the gel coat intact. This particular process is a patented technology of which Solidstrip®, Inc. is the exclusive licensee.

Plastic Media Blasting is quickly becoming the procedure of choice for coatings removal. Solidstrip® Plastic Abrasive is nontoxic, nonhazardous, and, with training, is safe for operators to use. When these factors are combined with the operational economics of PMB, a leading technology clearly emerges.

 
 
blue bar

Solidstrip®
P.O. Box 102
Minocqua, Wisconsin 54548
(715) 356-7130
FAX (715) 356-3952

solidstrip@plasticmedia.com

 

Copyright ©1994-2009 Solidstrip, Inc. All Rights Reserved.
 
Website by Northwoods Media